2013 Ford Explorer Backup Camera Not Working

2013 Ford Explorer Backup Camera Not Working. I only have 27k miles on it. It says to call dealership.

2013 Ford Explorer Backup Camera Reset

There is a chance it is a bad camera. In this case, you’ll usually see a no signal warning. However, this warning can also be resulted from loose wires or a camera that needs to be reset.

Web I Have A 2013 Ford Exployer And My Rear Backup Camera Has Intermittently Been Showing A Black Screen That Says ” See Dealership” To Show Objects On Opposite Side Of Camera Screen To Maybe Working Correctly 5%/10% Of The Time.

However, this warning can also be resulted from loose wires or a camera that needs to be reset. There is a chance it is a bad camera. By checking the fuse, wiring, camera, and display screen, you can narrow down the problem and determine the best solution.

Web How To Fix Backup Camera On 2013 Ford Explorer By John Adams | Oct 5, 2023 | Popular Models Are You Tired Of Backing Up Your 2013 Ford Explorer And Having To Rely On Your Handy Backup Camera?

Web 2011 2012 2013 2014 2015 ford explorer rearview backup reverse camera not working replacement 2013 to 2015 part number: Web why is my rear backup camera not working? Web i am finding the backup camera works immediately after a cold startup, or being parked for some time.

Web Most Of The Ford Rear Camera Stops Working Due To Slamming The Trunk Too Hard And Camera Would Be Loose.

Web for the record, i cannot confirm whether they did or not. However, this warning can also be resulted from loose wires or a camera that needs to be reset. The intermittent phase lasted about 2 months.

I Have Researched Replacements And Found Them For Around $200, But Have Not Located The Process For Actually Replacing It.

I’m still angry ford refuses to fix the door panel issue. In any case, if the guidelines are going. It says to call dealership.

Thankfully, I Purchased The Maxcare Extended Warranty And Had The Vehicle Serviced By Ford.

A few months later we finally get the car back and things seemed fine. Some say it's bad ground wire, some have replaced the whole camera. Go ahead and install a new fuse, and if the problem goes away you’re good to go.